1/33 Dornier DO-17P - ModelArt

I have finished this work in the past 40 days. Photos need some post-processing to comply with the law, so I publish them now.

I have reduced the original drawing to the exact 1/33 scale instead of the original 1/32

At the beginning, I tried using steel balls as molds, but I found it difficult to link with the following sections of glass, so I gave up this method. Try again to make a whole mold with plaster

This was just the beginning. When I found that plaster was difficult to polish, I changed other materials again. Synthetic resin is used this time

I used the paper on the surface of metal particles instead of the original white paper to make the engines

The next steps went smoothly

I separate the integrated parts, which will show a better three-dimensional feeling

I replaced the original slips of paper with solder wire

The final effect,

Dear all,

Thank you for your appreciation. I will continue to make new models and share the process with you.

I corrected a model designer's mistake based on the historical photos and turned the control pull rods of the elevator